KONDENS ÜNİTELER –  EVW

08Available range

Unit type
IR Condenserless unit
BR Condenserless unit Brine

Version
VB Base version
VD Desuperheaters version

Acoustic setting up
AB Base setting up
AS Low noise setting up

Unit description

This range of condenserless units are designed to meet the climate control and air conditioning needs of large capacity systems in the industrial and commercial sectors. All the units are suitable for indoor installation and can be applied to fan coil plants. Suitable for indoor installation, as standard the units are equipped with 1 or 2 TWIN-SCREW semihermetic compressors mounted on rubber vibration dampers able to modulate the capacity from minimum 25 (not for all configurations) to 100%, plant side exchanger shell and tube type complete with Victaulic water connections, fitted inside a shell of thermal insulation material to prevent condensation and heat exchange with the outside, optimised for R134a with high efficiency grooved tubes, protected by means of a water differential pressure switch, 1 or 2 independent refrigerant circuits, complete with electronic expansion valve which optimises unit efficiency at full and partial loads and enables maximum seasonal efficiency, maximum and minimum pressure switch, PED safety valves, dehydrator filter, liquid/ moisture indicator, compressor discharge and liquid shut-off valves, high and low pressure transducers, electrical panel with minimum protection IP54 containing the electrical equipment and all the components to control and command the unit complete with main supply breaker with door lock function, phase sequence control device, microprocessor controller with display (4 lines of 20 characters).

The units can be selected as Base setting up (AB) or as Low noise setting up (AS) that provides that compressor are positioned inside a soundproofed cabin, made with profiles and panels insulated with acoustic material.

The units are suitable to be combined with remote condensers cooled by air (coil and fans) or remote condensers cooled by water (plate or shel and tube heat exchanger). The electronic controller can manage the numerous ways used on the market for the head pressure control for condensation by air and for condensation by water. A wide range of options and accessories completes the commercial offer. All the units are carefully built in compliance with the current regulations and individually tested.

The units are supplied with charge of NITROGEN in order to avoid the entrance of air inside the refrigerant circuit.

Options
Compressor starting
standard (contactors)
soft starter
Compressors power factor correction
Electrical load protection
standard (fuses)
thermal magnetic circuit breakers
Evaporator flow switch (mounted)
Evaporator insulation higher thickness
Evaporator electrical heater for winter antifreeze
High and low pressure gauges
Compressor suction shut-off valve

Accessories
Rubber vibration dampers
External Water Storage Tank and Pumping Module complete with insulated carbon steel tank, single or twin pump and all hydronic components.
Antifreeze electrical heaters for Storage tank
Remote controller
Serial Interface Modbus on RS 485
Programmer clock
Phase sequence and voltage controller
Water flow switch
Remote condenser cooled by air

CONTROL SYSTEM
The units are equipped with a controller designed to ensure energy saving and unit efficiency.
Available functions:
Double Set Point
Demand Limit
Dinamic set point
Condensation control
Remote stand by